功能多樣性與實用性?

Functional diversity and practicality

清洗模式：具備多種清洗模式的超聲波清洗機更實用。如部分產品有標準清洗、深度清洗、快速清洗等模式，可根據物品材質、污漬程度靈活選擇。對于眼鏡上的重污漬，可選擇深度清洗模式；日常清潔則用標準模式即可。像萊科德 SU - 745 有五種智能清潔模式，配合高頻率超聲波，能有效應對不同清潔需求。?

Cleaning mode: Ultrasonic cleaning machines with multiple cleaning modes are more practical. If some products have standard cleaning, deep cleaning, quick cleaning and other modes, they can be flexibly selected according to the material of the item and the degree of stains. For heavy stains on glasses, deep cleaning mode can be selected; Daily cleaning can be done using standard mode. Like the Lecode SU-745, it has five intelligent cleaning modes, combined with high-frequency ultrasound, which can effectively meet different cleaning needs. ?

可視化設計：上蓋采用可視化設計，方便用戶隨時觀察清洗進度，無需打開蓋子查看，避免清洗中斷。如北柏、朗菲 C3 等超聲波清洗機的可視化上蓋，提升使用便捷性。?

Visual design: The upper cover adopts a visual design, which makes it convenient for users to observe the cleaning progress at any time without opening the cover, avoiding cleaning interruptions. Visualizing the upper cover of ultrasonic cleaning machines such as Beibai and Langfei C3 enhances the convenience of use. ?

便攜性與充電功能：一些超聲波清洗機配備鋰電池，可擺脫電源線束縛，方便外出攜帶使用。如固特 X5，內置 2500mAH 鋰電池，充滿電可清洗約 20 次，充電兩小時左右，滿足用戶移動清潔需求。

Portability and charging function: Some ultrasonic cleaning machines are equipped with lithium batteries, which can break free from the constraints of power cords and make it convenient to carry and use when going out. Like the Gute X5, it has a built-in 2500mAH lithium battery that can be cleaned about 20 times when fully charged, and can be charged for about two hours, meeting the mobile cleaning needs of users.

注意事項：

matters needing attention:

(1)超聲波清洗設備電源及電熱器電源必須有良好接地裝置。

(1) The power supply of ultrasonic cleaning equipment and electric heater must have a good grounding device.

(2)超聲波清洗設備嚴禁無清洗液開機，即清洗缸沒有加一定數量的清洗液，不得開啟超聲波開關。

(2) Ultrasonic cleaning equipment must not be turned on without cleaning solution, that is, the ultrasonic switch must not be turned on without adding a certain amount of cleaning solution to the cleaning tank.

(3)有加熱設備的清洗設備嚴禁無液時打開加熱開關。

(3) Cleaning equipment with heating devices is strictly prohibited from turning on the heating switch when there is no liquid.

(4)禁止用重物(鐵件)撞擊清洗缸缸底，以免能量轉換器晶片受損。

(4) Do not hit the bottom of the cleaning cylinder with heavy objects (iron parts) to prevent damage to the energy converter chip.

(5)超聲波發生器電源應單獨使用一路220V/50Hz電源并配裝2000W以上穩壓器。

(5) The ultrasonic generator power supply should use a separate 220V/50Hz power supply and be equipped with a voltage regulator of 2000W or above.

(6)清洗缸缸底要定期沖洗，不得有過多的雜物或污垢。

(6) The bottom of the cleaning cylinder should be regularly flushed to prevent excessive debris or dirt.

(7)每次換新液時，待超聲波起動后，方可洗件。

(7) When changing the liquid each time, wait for the ultrasonic wave to start before washing the parts.

本文由超聲波清洗機友情奉獻.更多有關的知識請點擊:http://www.heqingliang.cn我們將會對您提出的疑問進行詳細的解答，歡迎您登錄網站留言.

This article is dedicated to friendship For more information, please click: We will provide detailed answers to your questions. You are welcome to log in to our website and leave a message