歡迎訪問濟南科爾超聲波設備有限公司網站！

專注生產工業用超聲波清洗機

讓工業清洗無難事

業務咨詢電話：

18663767799

你所在位置：首頁-新聞動態-新聞資訊

新聞資訊

超聲波清洗機使用期要注意控制各因素

作者：admin來源：http://www.heqingliang.cn/時間：2022-08-08

使用合符設備規格的電源及電源線

Use power supply and power cord conforming to equipment specifications

根據安全要求需要連接到接地線，清洗劑應放置在清潔、干燥、腐蝕性強的氣體環境中，避免劇烈振動，發電機的后部應留下足夠的散熱空間。以確保超聲波清洗機有良好的接觸，避免發生人身傷害事故。

According to the safety requirements, it is necessary to connect to the grounding wire. The cleaning agent should be placed in a clean, dry and highly corrosive gas environment to avoid violent vibration. Sufficient heat dissipation space should be left at the rear of the generator. To ensure that the ultrasonic cleaning machine has good contact and avoid personal injury accidents.

嚴禁空載狀態下開機

It is forbidden to start the machine under no-load condition

超聲波清洗機開機前須使用說明的液位將清洗液倒入清洗槽中。被清洗物不得和槽底接觸，建議將工件放入籃筐中清洗。清洗液不得呈強酸或強堿性，無可靠的安全措施時，不能使用易燃溶液。清洗液在一年中的溫度會隨著連續工作時間的延長而增加，超聲波清洗機連續工作的時間不應超過規定時間。

Before starting the ultrasonic cleaning machine, the cleaning liquid must be poured into the cleaning tank with the liquid level specified. The object to be cleaned shall not contact with the bottom of the tank. It is recommended to put the workpiece into the basket for cleaning. The cleaning solution shall not be strong acid or strong alkaline. Flammable solution shall not be used without reliable safety measures. The temperature of the cleaning solution in a year will increase with the extension of the continuous working time. The continuous working time of the ultrasonic cleaning machine shall not exceed the specified time.
山東超聲波清洗機

設備采用不燃性洗凈劑

Non combustible detergent is used for the equipment

由于一些特殊原因需要使用易燃易爆易揮發的溶液作為介質時，會因為超聲波清洗機開始工作的時候，超聲波換能器會以每妙震動4萬次的頻率震動。

When it is necessary to use flammable, explosive and volatile solutions as media for some special reasons, the ultrasonic transducer will vibrate at a frequency of 40000 times per minute when the ultrasonic cleaner starts to work.

當超聲波換能器以如此高的頻率震動的時候自然會產生大量的熱量，這些熱量通過槽體散發，然后傳到清洗溶液之中，清洗溶液溫度開始提高，然后加速揮發速度，當空氣中的溶液濃度達到一定的值的時候，再碰到因振動而達到一定高溫震子，或者是發熱塊的時候，就是發生燃燒，或者爆炸。

When the ultrasonic transducer vibrates at such a high frequency, a large amount of heat will naturally be generated. These heat will be radiated through the tank body and then transferred to the cleaning solution. The temperature of the cleaning solution will start to increase, and then the volatilization speed will be accelerated. When the concentration of the solution in the air reaches a certain value, it will encounter a certain high-temperature vibrator or heating block due to vibration, which means combustion or explosion.

山東超聲波清洗機廠家建議不要把需要清洗的東西放在底端，應該要用專門清洗的支架進行架空放在中間的位置，這樣一來在進食的時候就可以均勻的受力獲得好的清洗效果。同時高端的超聲波清洗機廠家提醒還要注意到所放入的清洗液能量也應該要控制好，不能放太少否則可能會損壞儀器或者出現故障。

Shandong ultrasonic cleaning machine manufacturer recommends that the things to be cleaned should not be placed at the bottom end, but should be placed in the middle with a special cleaning bracket overhead, so that when eating, you can get a good cleaning effect. At the same time, the manufacturers of high-end ultrasonic cleaning machines remind that the energy of the cleaning liquid should also be well controlled, and not too little, otherwise the instrument may be damaged or malfunction may occur.

更多關于該設備的使用問題就來我們網站www.heqingliang.cn咨詢了解吧。

For more information about the use of this equipment, please visit our website www.heqingliang.cn.

上一篇：超聲波清洗機水溫調到多少比較好
下一篇：通過式清洗機的工作流程介紹