The practical significance of proper application of ultrasonic cleaning machine is firmly believed that everyone is clear, especially when starting up. In order to better and faster apply the ultrasonic cleaning machine, let's introduce the appropriate startup process of the ultrasonic cleaning machine. 1、 Ensure that no dirt falls into the bottom of the inner cavity of the ultrasonic cleaning machine. If any, be sure to eliminate it.

二，超聲波槽溫度做到設置所須要的加溫溫度，顯示燈滅掉，溫度掣全自動關閉電源，秸桿處于全自動控溫情況。

2、 The temperature of the ultrasonic tank shall be set to the required heating temperature, the display light shall be off, the temperature switch shall automatically turn off the power supply, and the straw shall be under full-automatic temperature control.

三，清洗液的高寬比也會危害清洗品質，對不一樣物品的清洗部位應探索其較好部位（注：清洗液的量與清洗槽的容積之比2/3）。

3、 The aspect ratio of cleaning fluid will also endanger the cleaning quality. For the cleaning parts of different articles, the better parts should be explored (Note: the ratio of the amount of cleaning fluid to the volume of the cleaning tank is 2 / 3).

四，將工件裝進清洗籃具，按清洗程序流程開展工件清洗。

4、 Put the workpiece into the cleaning basket and clean the workpiece according to the cleaning procedure.

五，流動性水中基本清洗器械后，將器械放進超聲波清洗機清洗過濾管內，務必應用清洗過濾管運載，全自動超聲波清洗線立即置放在超聲波清洗機內腔底端清洗。器械務必充足開啟，可拆卸的器械分離出來各部件；塑料吸管等長細空心器械張口朝下歪斜置放，確使腔內灌滿水溶液，清洗液液位泡過器械50mm。

5、 After basically cleaning the instrument in flowing water, put the instrument into the cleaning filter tube of the ultrasonic cleaning machine. Be sure to carry it with the cleaning filter tube. The full-automatic ultrasonic cleaning line shall be immediately placed at the bottom of the inner cavity of the ultrasonic cleaning machine for cleaning. The instrument must be fully opened, and the detachable instrument must separate all parts; The plastic straw and other long and thin hollow instruments are placed obliquely with the opening downward, so as to ensure that the cavity is filled with aqueous solution, and the liquid level of cleaning solution is 50 mm above the instrument.

六，蓋好超聲波清洗機的外蓋，設定清洗時間，逐漸超聲波清洗。超聲波清洗時間在3～5min，假如油水分離結構超聲波精度很高的工件不適合超出10min。

6、 Cover the outer cover of the ultrasonic cleaning machine, set the cleaning time and gradually ultrasonic cleaning. The ultrasonic cleaning time is 3 ~ 5min. If the oil-water separation structure, the workpiece with high ultrasonic accuracy is not suitable for more than 10min.

七，進行作業后，設備要停止工作，取下工件，關閉全部電源總開關就可以。

7、 After the operation, the equipment should stop working, remove the workpiece and turn off all the main power switches.