歡迎訪問濟南科爾超聲波設備有限公司網站！

專注生產工業用超聲波清洗機

讓工業清洗無難事

業務咨詢電話：

18663767799

你所在位置：首頁-新聞動態-新聞資訊

新聞資訊

超聲清洗機廠家分析與超聲波清洗與傳統清洗有什么不同？

作者：admin來源：http://www.heqingliang.cn/時間：2020-09-28

超聲波清洗機與傳統清洗方式相比，超聲波清洗有如下優點：

Compared with traditional cleaning methods, ultrasonic cleaning machine has the following advantages:

1．清洗更徹底

1. More thorough cleaning

超聲波清洗機原理表明該種方式非常適合清洗形狀復雜的構件。這類零部件若用人工清洗，有很多部位是難以或無法清洗到的。清洗劑只能溶解部分污垢，對于頑固污垢及零件內部的污垢也是力不從心。超聲波清洗機技術清洗是一種奇妙的物理清洗，猶如無數小炸彈同時爆破清除物體的內外表面，如再結合清洗劑的化學清洗，因此可以使傳統方法無法完成的內表面及內孔的清洗一次完成。

The principle of ultrasonic cleaning machine shows that this method is very suitable for cleaning complex shape components. If such parts are cleaned manually, many parts are difficult or impossible to clean. The cleaning agent can only dissolve part of the dirt, and it is not enough for the stubborn dirt and the dirt inside the parts. Ultrasonic cleaning machine technology cleaning is a wonderful physical cleaning, like countless small bombs blasting to remove the internal and external surface of the object at the same time, such as chemical cleaning combined with cleaning agent, so that the traditional method can not complete the internal surface and inner hole cleaning at one time.

2．節約能源

2. Energy saving

小型零部件的清洗目前多使用汽油或柴油刷洗，因此操作安全系數很低，易造成事故。而超聲波技術清洗使用水基清洗劑，絕無事故隱患。 v

At present, most of the small parts are cleaned with gasoline or diesel oil, so the safety factor of operation is very low, which is easy to cause accidents. But the ultrasonic technology cleaning uses the water-based cleaning agent, has no accident hidden danger.

超聲清洗機廠家分析與超聲波清洗與傳統清洗有什么不同？(圖1)

3．工作效率高

3. High efficiency

只需將零部件解體后放在清洗機的絲網料筐中并按一下開關即可自動清洗。

Just put the parts into the wire mesh basket of the cleaning machine and press the switch to clean them automatically.

4．清洗成本低

4. Low cleaning cost

因清洗劑重復使用率高，耗材采購廉價，在所有清洗方式中，清洗成本大體可分為：設備成本和消耗成本。超聲波清洗機設備使用壽命約為十年，除設備購置成本高于手工清洗和有機堿性溶劑刷洗外，低于氣相清洗和高壓水射流清洗。

Due to the high reuse rate of cleaning agent and the low cost of consumables procurement, the cleaning cost can be roughly divided into: equipment cost and consumption cost. The service life of ultrasonic cleaning machine is about 10 years. The cost of equipment purchase is higher than that of manual cleaning and organic alkaline solvent brushing, but lower than that of gas phase cleaning and high pressure water jet cleaning.

5.清洗效果好：就清洗方式而言，運用于工業清洗的清洗方式一般為手工清洗，有機溶劑清洗，蒸汽氣相清洗，高壓水射流清洗和超聲波清洗，根據清洗效果可以明顯地區分清洗的方式，超聲波清洗機被國際公認為當前效率高，效果好的清洗方式，其清洗效率達到了98%以上，清洗潔凈度也達到了高級別，而傳統的手工清洗和有機溶劑清洗的清洗效率僅僅為60%-70%，即使是氣象清洗和高壓水射流清洗的清洗效率也低于90%，因此，在工業清洗中，超聲波清洗機以其效率高，效果好，適用于大工作量清洗的特性無疑是清洗的佳選擇，這也是為什么凡是對潔凈度要求高的行業。

5. Good cleaning effect: as far as the cleaning methods are concerned, the cleaning methods used in industrial cleaning are generally manual cleaning, organic solvent cleaning, steam vapor cleaning, high pressure water jet cleaning and ultrasonic cleaning. According to the cleaning effect, the cleaning methods can be obviously distinguished. The ultrasonic cleaning machine is internationally recognized as the most efficient and effective cleaning method, and its cleaning efficiency is the best The cleaning efficiency of traditional manual cleaning and organic solvent cleaning is only 60% - 70%. Even the cleaning efficiency of meteorological cleaning and high-pressure water jet cleaning is less than 90%. Therefore, in industrial cleaning, ultrasonic wave cleaning machine is undoubtedly cleaning with its high efficiency and good effect, which is suitable for large workload cleaning The best choice, this is also why all the high cleanliness requirements of the industry.