用戶在使用碳氫清洗機中所遇到的各種問題，如：清洗不干凈有殘留、產品清洗刮花、產品氧化、發黃有白點等，碳氫清洗機小編整理了以下內容與大家分享，希望對使用碳氫清洗機的用戶在清洗操作中有所幫助。

Users encounter various problems in the use of the hydrocarbon washer, such as residue, scratches, oxidation, yellowing and white spots, etc. The following contents are compiled for sharing with you, hoping to help users of the hydrocarbon washer in the cleaning operation.

1、容易重疊的產品，建議是少量清洗，再清洗時多抖動，讓產品清洗更均勻。

1. For products that are easy to overlap, it is recommended to wash them in a small amount, and shake them more when washing again, so that the products can be cleaned more evenly.

2、清洗時間，根據清洗工件的結構、材質、油污及清洗方式的不同，所需的清洗時間也會有所差異。一般來說，油污較重零件的清洗時間可適當延長，油污較輕易于清洗的可縮短清洗時間，但是多單槽清洗不超過5分鐘。

2. The cleaning time is different according to the structure, material, oil stain and cleaning method of the workpiece. Generally speaking, the cleaning time of parts with heavy oil stain can be appropriately extended, and the cleaning time of parts with light oil stain that are easy to clean can be shortened, but the cleaning time of multiple single tanks shall not exceed 5 minutes.

3、碳氫清洗溶劑有一定的飽和度，達飽和度后應及時更換新液。理論上1L碳氫清洗劑可溶解0.8L的油污。

3. The hydrocarbon cleaning solvent has a certain degree of saturation, and the new liquid shall be replaced in time after reaching the saturation. Theoretically, 1L hydrocarbon cleaning agent can dissolve 0.8L oil stain.

4、定期檢碳氫清洗設備，避免設備故障影響清洗；注意清洗設備的功率調節，功率過大可能會打傷產品；風干設備調整干燥參數。

4. Check the hydrocarbon cleaning equipment regularly to avoid equipment failure affecting the cleaning; Pay attention to the power regulation of the cleaning equipment. Excessive power may damage the product; Air drying equipment adjusts drying parameters.

5、加強清洗作業車間的抽風及通風。

5. Strengthen the ventilation and ventilation of the cleaning workshop.

6、產品加工后及時清洗，避免人為污染，如：裸手接觸。建議是佩戴手套、口罩作業，以防止作業人員的手汗或說話時有少量的口水濺到產品上，造成產品上有氧化點形成。

6. Clean the product in time after processing to avoid man-made pollution, such as bare hand contact. It is recommended to wear gloves and masks to work, so as to prevent operators from sweating their hands or splashing a small amount of saliva on the product when talking, which may cause the formation of oxidation points on the product.

7、秋冬季氣溫較低，超聲波加溫清洗時建議提高清洗溫度，具體使用溫度，由供貨商提供相關參數。

7. The temperature in autumn and winter is low, so it is recommended to increase the cleaning temperature during ultrasonic heating cleaning. The supplier shall provide relevant parameters for specific use temperature.

8、存儲使用：應使用干凈無污染的油抽取清洗劑，取液后及時封蓋，避免揮發損耗。

8. Storage and use: clean and pollution-free oil shall be used to extract the cleaning agent, and the liquid shall be timely covered to avoid volatilization loss.

9、清洗劑損耗大：檢查是不是清洗籃紗網密度小，帶出液多, 通過更改清洗藍以減少清洗藍帶出清洗劑的消耗；清洗后無瀝干工序或是瀝干時間短，也可能是清洗劑損耗大的原因之一。

9. Large detergent loss: check whether the density of the cleaning basket gauze is small and more liquid is carried out. Change the cleaning blue to reduce the consumption of detergent carried out by the cleaning blue; No drainage process or short drainage time after cleaning may also be one of the reasons for high detergent consumption.

隨著國家對環保方面越來越重視，在可預見的未來，碳氫清洗機必將超越水基清洗機，成為工業清洗的主流品類。您有需求就來我們網站http://www.heqingliang.cn進行咨詢了解吧！

As the country pays more and more attention to environmental protection, in the foreseeable future, hydrocarbon cleaning machines will surely surpass water-based cleaning machines and become the mainstream category of industrial cleaning. Come to our website if you need http://www.heqingliang.cn Consult and understand!