噴淋清洗機具有工位多，功能全，結構合理，操作方便，清洗效果好,對于大批量工件的清洗，改善勞動環境，提高清洗和吹干質量，具有重要的意義。下面來講講噴淋清洗機使用方法以及注意相關內容吧。

The spray cleaning machine has many working positions, complete functions, reasonable structure, convenient operation and good cleaning effect. It is of great significance for the cleaning of large quantities of workpieces, improving the working environment and improving the cleaning and drying quality. Let's talk about how to use the spray washer and pay attention to relevant contents.

噴淋清洗機的使用方法：

Usage of spray cleaning machine:

(1)連接電源線。應根據電源的標簽進行鏈接。嚴禁接錯380V和220V。注意：加水前，先檢查風機運轉是否平穩后再加水。加水后，檢查輸送帶電機和水泵是否接反。如果反了，停機換線。（嚴禁在未接好接線前打開風扇按鈕，否則水會倒流造成風扇損壞）

(1) Connect the power cord. It shall be linked according to the label of the power supply. It is strictly forbidden to connect 380V and 220V incorrectly. Note: before adding water, check whether the fan operates stably before adding water. After adding water, check whether the conveyor belt motor and water pump are connected reversely. If it is reversed, stop the machine and change the line. (it is strictly forbidden to turn on the fan button before the wiring is connected properly, otherwise the water will flow back and cause damage to the fan)

(2)打開主電源開關。主電源開關采用急停開關設計，防止事故發生。可以緊急停止設備。

(2) Turn on the main power switch. The main power switch adopts the design of emergency stop switch to prevent accidents. The equipment can be stopped in an emergency.

(3)啟動風扇開關。由于高壓氣流，打開開關后，風扇可能會發出一定的噪音，不影響設備的使用。

(3) Activate the fan switch. Due to the high-pressure air flow, the fan may make some noise after the switch is turned on, which will not affect the use of the equipment.

(4)啟動網帶運行開關。（注：啟動網帶在啟動風扇后2-3分鐘啟動）。

(4) Start the mesh belt running switch. (Note: start the mesh belt 2-3 minutes after starting the fan).

(5)蒸汽源與蒸汽入口相連。

(5) The steam source is connected to the steam inlet.

(6)清洗機兩側有較大的清洗區，清洗方便。

(6) There is a large cleaning area on both sides of the cleaning machine, which is convenient for cleaning.

清洗機由繼電器全自動控制。除人工裝卸工件外，其余工藝流程均自動完成。

The cleaning machine is fully automatic controlled by the relay. Except for manual loading and unloading of workpieces, other technological processes are completed automatically.

使用噴淋清洗機的注意事項

Precautions for using spray cleaning machine

1、噴淋清洗機使用速度快，運行效果均勻，設備內外槽均采用不銹鋼材質。

1. The spray cleaning machine is fast to use and has uniform operation effect. The inner and outer tanks of the equipment are made of stainless steel.

2、噴淋清洗機設備是一種新型連續清洗設備，具有清洗液噴洗、噴水沖洗、風機吹水、熱風干燥等功能。

2. The spray cleaning machine is a new type of continuous cleaning equipment, which has the functions of cleaning liquid spray washing, water spray washing, fan blowing, hot air drying and so on.

3、由于設備的工作時間、溫度、功率都可以自行調節，對生產效率的提高有很大的幫助，在一定程度上可以節省大量的生產成本。

3. Since the working time, temperature and power of the equipment can be adjusted by themselves, it is very helpful to improve the production efficiency and save a lot of production costs to a certain extent.

4、噴淋清洗機設備在使用過程中，清洗機的儲液罐在罐內沒有水或溶劑的情況下需要更換。正確的操作和維護工作。

4. During the use of the spray washer equipment, the liquid storage tank of the washer needs to be replaced when there is no water or solvent in the tank. Correct operation and maintenance.

該機器對于大批量工件的清洗是非常不錯的選擇。不過同樣在操作過程中對于一些操作設備該注意的問題還是需要多加了解并注意，才能夠更好的操作使用設備。更多相關內容的了解就來我們網站www.heqingliang.cn吧。

This machine is a very good choice for cleaning large quantities of workpieces. However, in the same process of operation, the problems that should be paid attention to for some operating equipment still need to be understood and paid attention to in order to better operate and use the equipment. For more information, please visit our website at www.jnthcsb Com.